If you are in manufacturing, you know just how important it is to seal two surfaces that meet but do not have adequate cushioning. These two can cause issues of leakages if they are not correctly handled. The best way to go about it is to get Teflex Expanded PTFE Gasket to use in these areas. Since there are so many gaskets in the market, choosing the right gasketcan be a hassle. Here are some of the things you will consider to ensure you get the best gasket for the job.
1. The amount of force the gasket will be put between
Even though gaskets are meant to handle a lot of pressure, it all depends on the type of gasket you get. Smaller gaskets might not handle the higher pressures very well, so one might have to get a slightly bigger one. Before you buy a gasket, take the time to figure out how much pressure the two surfaces produce. Doing so will help you as you choose the gasket you want for your surfaces. It is also important to remember that bigger gaskets handle pressure better.
2. The surface unevenness
You use a gasket to deal with the surface’s unevenness and ensure there is no leakage from these areas. If an area is very uneven, you will definitely need a bigger gasket to help. Getting an engineer to look at the area is the best way to help you determine whether or not you are getting the right size gasket. A small gasket will not serve you if you have a huge uneven area, so bear that in mind.
3. The fluids passing through
Not all gaskets can handle the fluids passing through the area they are put in. The reason for this is, some of the materials used to make these gaskets are highly reactive. Therefore, it makes little sense for them to be put in areas with highly reactive fluids. The best way to go about this is to research the material used to make the gaskets. Materials like teflex are not so reactive would suit most, if not all, the fluids passing through.
On the other hand, metallic gaskets might react to some chemicals and contaminate whatever is passing through. Be keen on this point, especially if you want to have pure products at the end of a production line.
4. Compressibility of the gasket material
Gaskets are meant to get into tiny spaces and seal them up. For them to do this, they need to be highly compressible. Ensure that you can get a gasket made from a highly compressible material, as this will ensure that you do not have any spaces left because the gasket did not seal them up properly.
Final thoughts
Getting the right gasket is essential for anyone who works in manufacturing. It ensures that there are no leakages and that the production line can run without any issues. There are so many gaskets in the market, and you need to figure out which one suits your needs best. The tips above will go a long way in ensuring you get the right gasket material for your manufacturing plant.
